Tag Archives: CO

Storm Prep

Friends,

It’s been a while since our last storm, so a few quick reminders about safety related to energy efficiency. Remember, our safety personnel will likely have their hands full with other emergencies – let’s do them a favor by avoiding some of these basic hazards.

1. Clear direct vents: If you have a “direct venting” appliance such as a boiler or hot water heater, make sure the vents stay clear of snow. The vents are only a few feet off the

Typical direct vent exhaust as seen from outside the house.

Typical direct vent exhaust as seen from outside the house.

ground, so snow drifts can sometimes get in the way, especially if you’ve put anything under the vent. (Hint: Don’t put anything under the vent.)

If blocked, the CO from combustion will go into the home rather than outside. CO is known as a silent killer because there is no smell. Check the vent periodically throughout the storm.

2. Dryer vents: The same holds true for dryer vents – if snow or ice is blocking them they won’t function safely. In the case of a dryer this can lead to additional problems, like burning your house down. Until that happens, it can also dramatically rise the amount of time it takes to dry clothing, which wastes energy. Continue reading

Got CO?

It’s time to ‘spring forward’ which also means its time to replace the batteries in your smoke detectors AND CO monitors.

You do have carbon monoxide monitors, right? State law says that you must have carbon monoxide monitors on all living floors of your home. It isn’t required (but should be) in unfinished basements which is probably where your furnace, hot water heater and dryer are located. Continue reading